bearing cap造句

• Bearing cap oil seal remover
  轴承盖油封拆卸器
• Crankshaft bearing cap bolt
  曲轴轴承盖螺栓
• Connecting rod bearing cap
  连杆轴承盖
• Thrust bearing cap
  推力轴承盖
• Main bearing cap
  主轴承盖
• Remove both sway bar bearing caps and apply grease to the front pressure points . see pictures below
  取下两个防倾杆盖，并在前压力点涂上润滑油，见下图。
• This article studies on damaged round steel tube members and at the same time both material nonlinearity and geometric nonlinearity are considered in calculation . numerical integration method is planed to be adopted to analyses the ultimate bearing cap acity of damaged round steel tube members
  本文研究同时考虑材料非线性和几何非线性的特点，采用数值积分方法，对受损圆钢管轴压杆件的极限承载能力进行分析。
• In the simulation , the mpc technique of msc . nastran is used to simulate the mechanical behavior of contact between the interfaces of piston pin and bearing of small end , crankpin and big end bearing , connecting rod body and bearing cap ; also constraints are applied to the connecting rod reasonably
  分析中采用了patran中的多点约束( mpc )技术，有效地模拟了活塞销与小头孔内表面、曲柄销与大头孔内表面以及连杆体与大头盖接触面的力学接触状态，并对连杆进行合理的约束。